Let the washer run through a rinse and spin cycle to see if it drains.
Washer won t drain on spin cycle.
Then set your washer on the rinse cycle and turn it on.
5 minute zip tie repair of the lid switch gets your washer working again in minutes just need a phillips screw driver and a zip tie visit our website ht.
Remember to use less soap next time.
Remove the front panel screws.
If you have a top load washer a faulty lid switch could be stopping your machine from advancing to the drain or spin cycle.
To get rid of suds you can add a 1 4 cup of vegetable oil to the water in the tub then run a drain and spin cycle.
Make sure the hose is not pinched or kinked as this can cause it not to be able to facilitate the flow of water from the washer and adversely affect the spin cycle.
This would hinder water flow to and from the.
If your washer is not spinning and water is standing in the tub check for proper drain hose installation especially if your spin light is on.
It moves one direction to spin and the reverse direction to agitate.
A failed timer or problem with the drive motor can also prevent a top load washer from draining and spinning.
If the washer won t drain or spin either something is stuck in the washing machine drain hose or pump or the pump is broken.
Often the motor will stop working in just one direction meaning the machine might still agitate even if it won t spin.
This light will turn on after 10 minutes of the drain pump being on with no water level change.
We re showing the repair on a maytag washing machine.
If the lid switch fails your washer won t drain.
Another common reason a washer won t spin is a faulty drive motor.
Most washing machines have what is called a reversing motor.
If your washer is full of suds it can actually prevent it from draining properly.
Undo any kink in the hose.
You really only need about a tablespoon of detergent for loads in he washers.
If a washer won t drain or spin the fix is simple if you re even just a little bit handy with tools.
It s best to get a plumber or handyman to look at it.
In a top load washer a failed lid switch can keep the washer from advancing to the drain and spin cycle.
Located under the lid of the washer the lid switch detects whether the lid is closed.
As a result the washer won t reach adequate spin speeds leaving your clothes dripping wet at the end of the cycle.