The bottom strap must be located at least 4 away from the water heater controls.
Water heater strapping requirements california 2017.
How much does a water heater permit cost.
Located in attic cpc 508 4 the water heater shall be accessible through an opening and passageway at least large as the largest component of the appliance and not less than 22 by 30.
Lettering on the label shall be black on a red background and not less than 1 4 inch in height except for the word warning which shall be not less than 1 2 inch in height.
One located within the top 1 3 of the water heater unit and one at the bottom 1 3.
E 1 all fuel gas burning water heater appliances in new manufactured homes or new multifamily manufactured homes installed in the state shall be seismically braced anchored or strapped pursuant to paragraph 3 and shall be.
I would recommend them to anyone looking for excellent service.
The bottom strap must be located at least 4 away from the water heater controls.
You re only looking at 20 to 100 out of pocket as opposed to several hundred dollars to call in a plumber.
Rapid plumbing was the best.
Where the height of.
Water heaters require two seismic straps.
Seismic bracing cpc section 507 2 water heaters up to 75 gallons require two seismic straps.
Each water heater whether electric or gas needs to be strapped.
They were professional and prompt.
One located within the top 1 3 of the water heater unit and one at the bottom 1 3.
This appliance is approved only for use with liquified petroleum gas lpg.
The following are water heater installation requirements from the 2016 california codes.
The first permit is for the water heater itself.
At the lower point a minimum distance of four 4 inches shall be maintained above the controls with the strapping.
Strapping shall be at points within the upper one third and lower one third of its vertical dimensions.
These requirements apply to building permits submitted on or after january 1 2017.
They fixed my water softener problem in 2 hours from the time i called them.
Water heaters shall be anchored or strapped to resist horizontal displacement due to earthquake motion.
Even more the bottom strap needs to be four inches above the control unit.
Strapping shall be at points within the upper one third 1 3 and lower one third 1 3 of it s vertical dimensions.
Dual straps are compulsory with the first one placed on the lower one third of the unit and the second one placed along the upper third of the unit.