Put two cups sterilizer into the brine tank run two or three regeneration cycles then flush your pumping.
Water softener flush cycle.
After a period of time the resin beads get coated with hard minerals and need to be cleaned.
This is known as the water softener backwash cycle.
Flush with water softener cleaner.
No softened water will be available for home use until the regeneration cycle is complete.
The cleaning process is called recharge.
Backwash 10 minutes this step removed accumulated dirt and such while also fluffing up the media bed.
Water softeners regenerate by removing trapped contaminants and replacing them with either sodium or potassium depending on which chemical you put in the brine tank.
The brine solution flows through the resin tank rinsing the beads and exchanging new sodium for the hard water minerals that have collected.
So when a water softener runs it is in its regeneration or backwash cycle during which the softener pumps water into a salt tank to make brine then flushes the brine backwards through the water treatment tank then flushes the brine out of the treatment tank.
Once every few months pour water softener cleaner into the brine tank following label instructions.
Here are the typical water softener regeneration steps.
The recharge phase involves placing sodium ions into the saturated hard water.
Recharging consists of five stages.
Manually start a regenerating process or pour in the cleaner right before a scheduled regeneration.
You can manually set the water softener to perform an extra backwash and fast rinse cycle before the normal regeneration.
A strong salt water brine solution is created with the salt added to the softener.
To exclude this possibility sterilize your system with chlorine or hydrogen peroxide.
During a backwash of a water softener system water runs through a resin tank upward.
Depending on the size of your water softener a regeneration cycle typically takes about 30 to 60 minutes and uses anywhere from 40 to 60 gallons of water.
The following steps are involved with regeneration.
In the backwash phase the dirt inside the mineral tank which translates as residue from the previous regeneration process is flushed out through the drain and outside the water softener.
However the accumulation of bacteria in your softener may also be a cause of undrinkable brown water.
During regeneration the backwash cycle reverses the flow of water in the softener tank to lift loosen the resin bed and flush the gravel bed at the bottom of tank.
All the oxidized iron that has settled to the bottom of the tank gets stirred up and rusty dirty cloudy water will show up immediately after a regeneration for a day or so.
Water softener 5 recharge regeneration stages.
The times for each of these stages are variable and change just.