Water Softener Regeneration Steps

Backwash brine draw slow rinse and fast rinse.

Water softener regeneration steps.

A strong salt water brine solution is created with the salt added to the softener. This step takes about 10 minutes. The majority of home water softeners are equipped with automatic regeneration devices. Water softeners regenerate by removing trapped contaminants and replacing them with either sodium or potassium depending on which chemical you put in the brine tank.

The following steps are involved with regeneration. Here are the typical water softener regeneration steps. Backwash 10 minutes this step removed accumulated dirt and such while also fluffing up the media bed. The regeneration process starts with a backwash during which the softener pumps water backward through the treatment medium to remove sediment.

The third and last step of the regeneration is to pass a high capacity flush of water through the mineral to ensure salt free water goes to the tap. These devices work by either using a clock or by monitoring the amount of water used demand initiated regeneration softeners to tell the water softener when it is necessary to shut down and regenerate. The brine solution flows through the resin tank rinsing the beads and exchanging new sodium for the hard water minerals that have collected. To regenerate a softener that has reached capacity you must conduct four steps.

You can set a water softener to regenerate at a specific time that best fits your family s schedule. To understand the water softener s regeneration process you first have to find out what are the different parts and how they work. The softener then goes back into what we call service position and the owner enjoys another 1 200 gallons plus or minus of soft water.